Bit Switches - 1
No
Function
0-1
Not used
Enable/disable for direct
sending selection
2
0: Direct sending off
1: Direct sending on
Action when the external
handset goes off-hook
3
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the same)
4-7
Not used
D361/D510
System Switch 0E (SP No. 1-101-015)
Do not change the settings.
Direct sending cannot operate when the
capture function is on during sending. Setting
this switch to "1" enables direct sending without
capture. Setting this switch to "0" masks the
direct sending function on the operation panel
so it cannot be selected.
0: Manual tx and rx are possible while the
external handset is off-hook. However, memory
tx is not possible.
1: The display stays in standby mode even
when the external handset is used, so that
other people can use the machine for memory
tx operation. Note that manual tx and rx are not
possible with this setting.
Do not change these settings.
84
Comments
SM