Controller Options
2.23.8 HDD ENCRYPTION UNIT
Installation
Seal Check and Removal
1.
Check the box seals [1] on each corner of the box.
Make sure that a tape is attached to each corner.
2.
Open the box.
Installation Procedure
1.
Make sure that the following settings are not at the factory default settings:
Supervisor login password
Administrator login name
Administrator login password
These settings must be set up by the customer before the encryption option
can be installed.
2.
Confirm that "Admin. Authentication" is on:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Admin. Authentication"> "On"
If this setting is "Off" tell the customer that this setting must be "On" before you can do
the installation procedure.
3.
Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Available Settings
SM
2-102
D017/D018/D019/D020/D084/D085