Ricoh D017 Service Manual page 833

Two G3 Units
1. Connect the G3 interface units [A] and [B] to the CCUIF [C] (edge connector).
Fasten the connected G3/CCUIF to the cover [D].
G3: ( x2 ea.)
CCUIF ( x4)
2. Connect the FCU [E] and CCUIF [B] (FFC x1).
3. Reconnect the speaker harness [F] (
4. One and Two G3 Units connect the telephone lines to the back of the machine at
LINE 2 (single port) or LINE 2 and LINE 3 (dual port).
5. Plug in the machine. Then turn the main switch on.
6. Enter the Fax SP mode and set Bit 1 of Communication Switch 16 to "1" if you install
the single port.
-or-
Enter the Fax SP mode and set Bit 3 of Communication Switch 16 to "1" if you install
the dual ports.
7. Print the system parameter list. Make sure that "G3-2" (single port) and "G3-3" (dual
port) are listed as an option.
8. Set up and program the item required for PSTN-2 communication.
SM
x1)
15
Installation
D361/D510