Ricoh D017 Service Manual page 845

Code Meaning
The line was
disconnected due to
0-84 abnormal signaling in
V.34 phase 4 – control
channel start-up.
The line was
disconnected due to
0-85 abnormal signaling in
V.34 control channel
restart.
The line was
disconnected because
the other terminal
0-86 requested a data rate
using MPh that was not
available in the currently
selected symbol rate.
The control channel
started after an
0-87
unsuccessful primary
channel.
The line was
disconnected because
PPR was
0-88
transmitted/received 9
(default) times within the
same ECM frame.
SM
Suggested Cause/Action
The signal did not stop within 10 s.
Turn off the machine, then turn it back on.
If the same error is frequent, replace the FCU.
The signal did not stop within 10 s.
Turn off the machine, then turn it back on.
If the same error is frequent, replace the FCU.
The other terminal was incompatible.
Ask the other party to contact the
manufacturer.
The receiving terminal restarted the control
channel because data reception in the primary
channel was not successful.
This does not result in an error
communication.
Try using a lower data rate at the start.
Try adjusting the cable equalizer setting.
27
Error Codes
D361/D510