Ricoh D017 Service Manual page 141

6. Attach Antenna 1 [A] to the left front corner of the machine. (The core on the Antenna 1
cable is black.)
7. Set the cable of Antenna 1 in the clamps and close them.
8. Remove the seals from the cable clamps and attach them to the rear of the machine as
shown above.
9. Attach Antenna 2 [B] to the right rear corner of the machine.
10. Set the cable of Antenna 2 in the clamps and close them.
User Tool Settings for IEEE 802.11a/g
Go into the User Tools mode and do the procedure below. These settings take effect every
time the machine is powered on.
You cannot use IEEE 802.11a/g if you use Ethernet.
1. Press the "User Tools" key.
2. On the touch panel, touch "System Settings".
The Network I/F (default: Ethernet) must be set for either Ethernet or wireless
LAN.
3. Select "Interface Settings"> "Network"> "Network I/F Setting"
4. Press "IEEE 802.11". Only the wireless LAN options show.
5. Set the Communication Mode. Select either "802.11 Ad hoc", "Ad hoc" or
"Infrastructure".
6. Enter the SSID setting. (The setting is case sensitive.)
7. Set the Channel. You need this setting when Ad Hoc Mode is selected.
Range: 1 to 14 (default: 11)
The allowed range for the channel settings may vary for different countries.
8. Do the WEP (Encryption) Setting.
The WEP (Wired Equivalent Privacy) setting is designed to protect wireless data
transmission. The same WEP key is required on the receiving side in order to
unlock encoded data. There are 64 bit and 128 bit WEP keys.
WEP: Select "Active" or "Inactive". ("Inactive" is the default.)
Range of Allowed Settings: 64-bit (10 characters) or 128-bit (26 characters)
D017/D018/D019/D020/D084/D085 2-95
Controller Options
SM