Ricoh D017 Service Manual page 948

Bit Switches - 4
No
3-5 Not used
G3 mode selection for the direct
connection
6
0: Off
1:On
7 Not used
No Function
0 Not used
1-3 Not used
DIS frame length
4
0: 10 bytes 1: 4 bytes
5 Not used
Forbid CED/AMsam output
6 0: Off
1: On (Forbid output)
7 Not used
D361/D510
G3 Switch 00 (SP No. 1-105-001)
Function
G3 Switch 01 (SP No. 1-105-002)
Do not change the settings.
Do not change the settings.
1: The bytes in the DIS frame after the 4th byte
will not be transmitted (set to 1 if there are
communication problems with PC-based faxes
which cannot receive the extended DIS frames).
Do not change the setting.
Do not change this setting (Default: 0: Off),
unless communication problem is caused by a
CED or ANSam transmission.
Do not change the setting.
Comments
Do not change the settings.
1: G3 communication through the direct line
is enabled.
Do not change the settings.
Comments
130 SM