Bit Switches - 6; Ip Fax Switches - Ricoh D017 Service Manual

4.8 BIT SWITCHES - 6

Do not adjust a bit switch or use a setting that is described as "Not used", as this
may cause the machine to malfunction or to operate in a manner that is not
accepted by local regulations. Such bits are for use only in other areas, such as
Japan.
Default settings for bit switches are not listed in this manual. Refer to the System
Parameter List printed by the machine.

4.8.1 IP FAX SWITCHES

No. Function
0 Not used
IP Fax Transport
1
0: TCP, 1: UDP
IP Fax single port selection
2
0: OFF, 1: ON (enable)
IP Fax double ports (single data
3 port) selection
0: OFF, 1: ON (enable)
IP Fax Gatekeeper
4
0: OFF, 1: ON (enable)
IP Fax T30 bit signal reverse
5
0: LSB first, 1: MSB first
IP Fax max bit rate setting
6
0: Not affected, 1: Affected
SM
IP Fax Switch 00 (SP No. 1-111-001)
Do not change this setting.
Selects TCP or UDP protocol for IP-Fax
Selects single data port.
Selects whether IP-Fax uses a double port.
Enables/disables the gatekeeper for IP-Fax.
Reverses the T30 bit signal.
When "0" is selected, the max bit rate does
not affect the value of the DIS/DCS.
When "1" is selected, the max bit rate
affects the value of the DIS/DCS.
145
Bit Switches - 6
Comments
D361/D510