Ricoh D017 Service Manual page 449

System SP Tables-2
2301* Transfer Current Adjust
Normal Paper
Adjusts the current applied to the transfer roller during copying from a paper
tray when the user uses the "Normal" paper setting.
1*
If the user normally feeds thicker paper from a paper tray, use a higher
setting.
[0 = –2
Thick/Thin Paper
Adjusts the current applied to the transfer roller during copying from the
by-pass tray. These settings are also used if the 2nd tray is used and special
paper is selected.
2*
If the user normally feeds thicker paper from the by-pass tray/2nd tray
(special paper), use a higher setting. If waste toner is re-attracted from the
drum (this can occur when using an OHP sheet), use a higher setting.
[0 = –2
Duplex Side 2
Adjusts the current applied to the transfer roller during copying from the
duplex unit when the user uses the "Normal" paper setting.
3*
Use this SP when the image on the rear side of the paper has a problem
caused by poor image transfer.
[0 = –2
Cleaning
Adjusts the current applied to the transfer roller during roller cleaning.
4*
If toner remains on the roller after cleaning (dirty background appears on the
rear side of the paper), increase the current.
[–10 to 0 / –4 / 1
D017/D018/D019/D020/D084/D085
A / 1 = 0 A / 2 = +2
A / 1 = 0 A / 2 = +2
A / 1 = 0 A / 2 = +2
A /step]
A / 3 = +4 A]
A / 3 = +4 A]
A / 3 = +4 A]
4-16 SM Appendix