Ricoh D017 Service Manual page 440

indicates the amount of paper remaining in the tray when the setting
will take effect. For example, "B4,LG 70%" means the setting will
take effect when B4 or Legal size paper is loaded in the tray and
70% of the paper remains in the tray.
The "Initial" notation in the display indicates the default value for the
setting. A positive number (+) indicates the length of time (ms) the
lift motor runs forward to raise the bottom plate and increase
pressure. A negative number (-) indicates the length of time (ms) the
lift motor runs in reverse to lower the bottom plate and reduce
pressure.
Please note that the "Initial" settings for some settings are negative
(reverse run time), others are positive (forward run time).
Note: Before doing any adjustments with these SP codes, confirm that
the correct paper size has been selected for each tray with SP codes
1912, 1913, 1914, 1915.
1 A3, DLT:100%
---
56 A5T:70%->30%
1912 Tray 1: Auto Paper Size Detection
1913 Tray 2: Auto Paper Size Detection
1914 Tray 3: Auto Paper Size Detection
1915 Tray 4: Auto Paper Size Detection
Some paper sizes are very nearly the same (A4, LT for example). The paper
size sensors are not sensitive enough to distinguish between such paper
sizes. Use these SP codes to select the paper size for the tray. A setting can
be done for each tray:
SM Appendix
To correct feed problems for a paper size, be
sure to set all four settings (100%, 70%,
30%, 10%) for each paper size that is
causing problems.
The "T" notation denotes "SEF" (Short Edge
Feed).
The "Y" notation denotes "LEF" (Long Edge
Feed)
4-7 D017/D018/D019/D020/D084/D085
System SP Tables-1