Configuring Telnet; Figure 3.9 [Network Interface] Window (Example) - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 3 Work before Operating System Installation
Operations
1. Click [Network Configuration] - [Network Interface].
>> The [Network Interface] window appears. For details on the [Network Interface] window, see 1.5.2
[Network Interface] window in the PRIMEQUEST 1000 Series Tool Reference (C122-E110EN).

FIGURE 3.9 [Network Interface] window (example)

2. Enter values in [IP Address], [Subnet Mask], and [Gateway Address] in [Virtual IP Address]. Also specify
the host name.
Remarks
Set the physical IP addresses and virtual IP addresses of MMB#0 and MMB#1 in the same subnet.
3. Click [Enable] for [Interface] in [MMB#0 IP Address] or [MMB#1 IP Address]. Then, enter a value in each
item. Specify a physical IP address to assign it at this time.
4. Specify the required fields. Then, click the [Apply] button.
Note
If the IP address or some other set value is invalid, the browser does not display the MMB Web-UI. In such cases,
connect the MMB console PC to the COM port on the MMB. Then, set the correct value.
3.3.7

Configuring telnet

Configure telnet for the MMB.
For details on how to back up the specified information, see
Note
3.5 Saving Configuration
33
Information.
C122-E107-09EN