Fujitsu PRIMEQUEST 1000 Series Installation Manual page 302

PRIMEQUEST 1000 Series Installation Manual
APPENDIX E Notes on VMware Installation
PortGroup Name VLAN ID Used Ports Uplinks
\: This indicates that there is no line feed.
2. Execute the esxcfg-vswtich command to connect the physical adapter vmnic0 to the virtual switch.
# esxcfg-vswitch -L vmnic0 vSwitch1
# esxcfg-vswitch -l
Switch Name Num Ports Used Ports Configured Ports \
MTU Uplinks
vSwitch0 64
1500 vmnic1
PortGroup Name VLAN ID Used Ports Uplinks
VM Network
Service Console 0
vSwitch1
1500 vmnic0
PortGroup Name VLAN ID Used Ports Uplinks
3. Add the port group (PSA-MMB) to the created switch.
# esxcfg-vswitch -A PSA-MMB vSwitch1
# esxcfg-vswitch -l
Switch Name Num Ports Used Ports Configured Ports \
MTU Uplinks
vSwitch0 64
1500 vmnic1
PortGroup Name VLAN ID Used Ports Uplinks
VM Network
Service Console 0
vSwitch1 64
1500 vmnic0
PortGroup Name VLAN ID Used Ports Uplinks
PSA-MMB
4. Execute the esxcfg-vswif command to create a virtual port (vswif1).
The IP address to be set depends on the partition number.
Use the values in the table below.
2
0 0
1
64 2
2
0 0
1
2 64 \
0 0
64 \
vmnic1
vmnic1
64 \
64 \
vmnic1
vmnic1
vmnic0
274 C122-E107-09EN