Fujitsu PRIMEQUEST 1000 Series Installation Manual page 108

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 4 Installing the Operating System and Bundled Software
For direct transfer of a PSA expansion trap from a partition, set the SNMP trap destination and PSA trap
notification. For details, see
Remarks
You can confirm a trap destination setting by using the standard trap of the SNMP service. (See
confirm a trap destination setting
7. Set the destinations of SNMP traps and e-mail via the MMB.
Make settings only as needed, such as for linkage with operations management software.
1. Display the [SNMP Configuration] menu in the MMB window, and enable SNMP.
2. Set the destinations of SNMP traps via the MMB.
(See 7.5.2 Configuring
8. Configure the firewall.
For Windows Server 2003: See
For Windows Server 2008: See
For Windows Server 2012: See the ServerView Mission Critical Option User Manual.
9. Set the Watchdog Timer for monitoring after a STOP error. For details, see
for monitoring after a STOP error (fatal system
1. Edit the PSA configuration file [pnwatchdog.conf].
2. Set the following key values:
Section: [WATCHDOG]
Key: [TIMER]
Setting value (unit: seconds): 0 (Watchdog Timer disabled), 1 to 6000 (Watchdog Timer monitoring
time)
10. Set the management LAN IP address.
Make this setting only if you need to change the management LAN IP address. For details, see
the management LAN IP
11. Install updates of PSA and other bundled software.
Check the latest versions of the software at their download sites, and install the necessary updates. For details
on PSA, see 6.3.8 Installing a PSA
12. Configure the dump area.
Confirm that the hard disk has enough free space before collecting a memory dump. For details, see 11.4.4
Setting up the dump environment (Windows) in the PRIMEQUEST 1000 Series Administration
Manual (C122-E108EN).
13. Configure the NTP client.
Configure the NTP server on the operating system side. For details, see
14. Save management and configuration information. For details, see
Information.
6.3.3 Setting the destinations of traps from a
in 6.3.3 Setting the destinations of traps from a
SNMP.)
6.3.5 Configuring the Windows
6.4.6 Configuring the Windows
error).
address.
update.
80
partition.
partition.)
Firewall.
Firewall.
6.3.6 Setting the Watchdog Timer
7.2 Configuring NTP.
6.8 Saving Management and Configuration
How to
6.3.7 Setting
C122-E107-09EN