Configuring Bundled Software After The Completion Of Installation; Table 4.14 Ports To Open For The Psa-To-Mmb Communication Lan Interface - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 4 Installing the Operating System and Bundled Software
Remark
The IP address of the LAN cannot be set through the operating system setup. Set the IP address after the
installation of the operating system.
7. Click [Install].
Installationbegins.
8. Replace the media with the operating system installation media according to the SVIM instructions.
4.11.4

Configuring bundled software after the completion of installation

After completing OS installation, configure the bundled software.
For details about the following settings, see the ServerView Mission Critical Option User Manual.
1. Configure the PSA-to-MMB communication LAN network.
For details, see the items in "Configuring the PSA-to-MMB communication LAN."
2. Configure the management LAN network.
For details, see the items in "Confirming management LAN settings."
3. Install the SVmco package.
For details, see the items in "Installing SVmco."
4. Make manual settings in the SVmco configuration file.
For details, see "Configuring SVmco."
5. Check the firewall function.
For details, see the items in "Checking the firewall function (opening ports)."
Open the following ports for use with the PSA-to-MMB communication LAN interface.

TABLE 4.14 Ports to open for the PSA-to-MMB communication LAN interface

Port
snmp port
psa-mmb
communication port
6. Restart the partition.
For details, see the items in "Restarting the partition."
7. After installing SVmco, make the required settings.
Set the management LAN parameters.
For details, see the items in "Settings after SVmco installation."
Port number
udp/snmp or 161
tcp/5000
icmp/icmp-type0, icmp-type8
113
Sending / Receiving
For sending and receiving
For sending and receiving
C122-E107-09EN