PRIMEQUEST 1000 Series Installation Manual
CHAPTER 4 Installing the Operating System and Bundled Software
4.11
SUSE Linux Enterprise Server 11 Service Pack 2 Installation
Procedures on the Built-in HDD
This section concisely describes the procedures for installing SUSE Linux Enterprise Server 11 Service Pack 2
(referred to below as SLES11 SP2) on the built-in HDD. Confirm the MMB configuration and successful login to
the MMB before starting the installation.
4.11.1
Advance setup
Set up the following as needed.
1. Remove each built-in HDD that is not the installation destination.
2. Confirm the partition settings of the PRIMEQUEST server with the MMB. For details, see
a
Partition.
- Setting the SB/IOB/G
- Setting the SB/IOB/GSPB configuration
(See
3.4.1 Setting a partition
- Configuring Console Redirection
(See
3.4.6 Configuring Console
- Video redirection: Enable
- Remote storage: Enable
- Console redirection: Enable
- Setting various modes
(See
3.4.5 Setting various
3. Assign I/O spaces to the SAS card, SASarray controller card, Onboard SAS controller (GSPB), SAS disk
unit controllerand SAS array disk unit controller.
For details on I/O space assignment, see 3.4.5 Setting various modes in this manual and 5.5.1 [Configure I/
O Space Assignment] menu in the PRIMEQUEST 1000 Series Tool Reference (C122-E110EN).
4.11.2
Preparing for Installation
Prepare the SLES11 SP2 installation DVD.
4.11.3
Installing the operating system
This section describes the operating system installation with SVIM.
SVIM can perform the following types of operating system installation. For the procedure for each mode, see
theServerView Suite ServerView Installation Manager.
TABLE 4.13 Operating system installation by SVIM
Mode
Quick mode
You can simply use the minimum
settings necessary for operating
configuration.)
Redirection.)
modes.)
Functional outline
110
Remarks
Use this mode to readily install
the OS.
3.4 Configuring
C122-E107-09EN