Configuring The Default Gateway; Figure E.7 Vmware Vsphere 4.X Client - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
APPENDIX E Notes on VMware Installation
#esxcfg-firewall -q
Opened ports:
SNMP
PSA-MMB
E.4.3

Configuring the default gateway

Configure the default gateway when installing the operating system.
If the default gateway is not configured for some reason, make this setting.
1. Execute the route command to specify a temporary default gateway.
route add default gw <GATEWAY>
Example: When specifying 192.168.0.1 as the default gateway
# route add default gw 192.168.0.1
2. Use VMware vSphere 4.x Client to connect to the service console, and then configure the default gateway
from the service console.
1. Start VMware vSphere 4.x Client.
2. Select [Home] - [Inventory] - [Inventory], and then click the [Configuration] tab.
3. Click [DNS and Routing] in the [Software] area in the lower left of the window.
4. Click [Properties] in the upper right of the window displaying the [DNS and Routing] information.

FIGURE E.7 VMware vSphere 4.x Client

: port 161 udp.in
: port 5000 tcp.out
277 C122-E107-09EN