Fujitsu PRIMEQUEST 1000 Series Installation Manual page 159

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
The PSA-to-MMB communication LAN is usually set with the following values during PSA installation.
<IP address>
172.30.0.<partition ID + 2>/24
Example: Partition ID of 2
172.30.0.4/24
<Communication settings>
Auto Negotiation off
Speed 100 Mbps
Duplex full
In the following cases, change the IP address setting.
1. The automatically set IP address is the same as the IP address or subnet used for a production network or
management network.
2. You are configuring a new partition using a duplicate disk from another partition.
3. The partition ID changes because a disk installed in a partition was moved to another partition.
Change the IP address setting by using the following procedure. If you are changing the setting because of the above
reason 1, you need to change the IP addresses of all partitions in the cabinet and the IP address of the PSA-to-MMB
communication LAN on the MMB side to IP addresses in the same subnet. Change the IP addresses on the MMB
side from the MMB Web-UI.
Notes
- Do not change the automatically set communication values. Otherwise, PSA-MMB communication may be
disabled, making PSA functions unavailable.
- Change PSA-to-MMB LAN settings only after PSA installation. If changed before PSA installation, the
settings are overwritten by the installation.
- If [Interface] of [MMB-PSA IP Address] in the [Network Configuration] - [Network Interface] window of
the MMB Web-UI is Disable, you can use neither the screen display nor event notification function of PSA.
After changing it from Disable to Enable, the OS must be restarted.
Confirming the NIC of the PSA-to-MMB communication LAN
Confirm the interface name assigned to the NIC of the PSA-to-MMB communication LAN by using the following
procedure.
Operations
1. Execute the ifconfig command to confirm the interface name. This command lists the network interfaces
recognized by the system.
Syntax
/sbin/ifconfig -a
Example of output
131 C122-E107-09EN