Confirming Management Lan Settings; Setting The Destinations Of Traps From A Partition - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
2. Select [PSANIF] from the displayed list. Then, select [Properties] from the right-click menu.
Notes
- If there is no connection named [PSANIF], PSA has probably not been installed. Always change the
settings after PSA installation.
- Do not change the connection name [PSANIF]. Otherwise, the settings can be overwritten by the
automatically set values in a PSA update.
3. Select [Internet Protocol (TCP/IP)]. Then, click the [Properties] button.
>> The [Internet Protocol (TCP/IP) Properties] dialog box appears.
4. Set the IP address and subnet mask.
5. To apply the NIC settings for the dedicated PSA-to-MMB communication LAN, restart PSA by using the
following steps.
Select [Control Panel] - [Administrative Tools] - [Services].
Right-click [PRIMEQUEST Server Agent] in the right side of the window. Then, select [Restart].
Making settings through a remote desktop connection
To configure the PSA-to-MMB communication LAN through a remote desktop connection, you need a console
session connection. Establish this connection by using the following procedure.
1. Select [Start] - [Run].
>> The [Run] dialog box appears.
2. Enter "mstsc /v:<servername/ip address>/console" in the [Open] field. Then, click the [OK] button.
Specify the connected server name or the IP address in <servername/ip address>. (You cannot specify its
virtual IP address in the cluster.)
You can check the details of mstsc options by entering "mstsc /?".
6.3.2

Confirming management LAN settings

Make settings for the management LAN. If necessary, also configure any duplication with teaming or GLS, for
example.
After completing the above network settings for the management LAN, perform the operations in
management LAN IP address.
Note
In the PRIMEQUEST environment, it is necessary to specify OFF for the STP function of the switch that connects
to the management LAN used for communication with the MMB.
6.3.3

Setting the destinations of traps from a partition

For direct transfer of a PSA expansion trap from a partition, set the trap destination and PSA trap notification by
using the following procedure.
Remarks
- SNMPv3 is not supported in Windows.
153
6.3.7 Setting the
C122-E107-09EN