Table B.3 Packages Required For Sirms Operation (Rhel6) - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
APPENDIX B Manual PSA Installation and Uninstallation

TABLE B.3 Packages required for SIRMS operation (RHEL6)

Package
Linux package
Note
The name of the FJSVfefpcl-related package depends on the operating system version.
Syntax
/bin/rpm -q <package name>
Use the uname command to check the kernel version.
Syntax
/bin/uname -r
Example of installing the net-snmp package and confirming the installation
#/bin/rpm -q net-snmp
net-snmp-5.1.2-11
If a package has not been installed, install it from the OS installation CD by using the same procedure as that for
the RPM package.
Remarks
The FJSVfefpcl package runs together with PSA to enable the functions for stopping Watchdog software and
reporting the panic status at the OS panic occurrence time.
Also, a configuration using PCL (PRIMECLUSTER) provides an HBA blocking function to obtain high-speed
switching of PCL nodes.
Under a PRIMEQUEST environment, the package must be installed even if PCL (PRIMECLUSTER) is not used.
Confirming the status of the iptables service
Confirm the status of the iptables service.
If the iptables service has stopped, the iptables settings were not made correctly during PSA installation.
Start the iptables service as needed.
Note
If PSA version 2.8.0 or earlier is installed when the iptables service has stopped, the iptables service starts with the
settings of the PSA-to-MMB communication LAN written over the existing port settings.
Deal with this problem in the following way.
- To use the iptables service:
Start the iptables service before installing PSA.
x86
Not required
CPU architecture
x64
libstdc++-4.4.4-13.el6.i686 or later
236 C122-E107-09EN