Setting The Destinations Of Traps From A Partition - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
Port
icmp
icmp
Syntax
/sbin/iptables -L
Use a command such as iptables to open ports. For details on how to use the command, see the respective manual
(such as with the man command).
/usr/bin/man iptables
6.2.5

Setting the destinations of traps from a partition

Direct transfer of a PSA expansion trap from a partition requires that the trap destination and PSA trap notification
be set on the partition.
Remarks
- Make settings only as needed.
- Even if this setting is skipped, traps are sent via the MMB.
- Operations management software needs these settings to manage events by partition.
Operations
1. Edit the /etc/opt/FJSVpsa/user/psatrap.conf file.
Example of setting PSA trap notification
#vi /etc/opt/FJSVpsa/usr/psatrap.conf
Change the following line.
[PSATRAP]
PSATRAP_SET=<0 or 1>
Setting value
1: Enables PSA trap notification from the partition.
0: Disables PSA trap notification from the partition.
Port number
Example of a case where port 5000
need not be set:
iptables -A OUTPUT -m state --state
NEW,ESTABLISH -j ACCEPT
iptables -A INPUT -m state --state
ESTABLISH -j ACCEPT
echo-request
echo-reply
Description
140
Remarks
For sending only
For receiving
only
C122-E107-09EN