Fujitsu PRIMEQUEST 1000 Series Installation Manual page 161

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
bus-info: 0000:00:19.0 (Corresponds to NIC of PSA-to-MMB
communication LAN)
Configuring the NIC of the PSA-to-MMB communication LAN
Configure the NIC of the PSA-to-MMB communication LAN by using the following procedure.
Operations
1. Edit the ifcfg file of the corresponding interface in /etc/sysconfig/network-scripts.
- NIC interface file name for the PSA-to-MMB communication LAN: ifcfg-<NIC interface name>
Example: ifcfg-eth0
Change the IP address by editing the ifcfg file of the interface.
The following example shows a command for editing the ifcfg file of the NIC interface for the PSA-
to-MMB communication LAN.
# vi /etc/sysconfig/network-scripts/ifcfg-<NIC
interface name>
Change the following lines:
BROADCAST=<BROADCAST address of PSA-to-MMB
communication LAN>
IPADDR=<IP address of PSA-to-MMB communication LAN>
NETMASK=<Subnet mask of PSA-to-MMB communication LAN>
Notes
- Before changing the settings, confirm that the settings in the ifcfg file have the values that were
automatically set during PSA installation. If they do not have the automatically set values, PSA may
not have been installed. Always change the settings after PSA installation.
- Do not change any line, including comment lines, except those with the items that must be changed
(BROADCAST, IPADDR, and NETMASK). Otherwise, PSA-MMB communication may be disabled,
making PSA functions unavailable. Moreover, a PSA update may overwrite the automatically set
values.
2. Restart the network service to activate the network interface.
Syntax
/sbin/service
3. Restart PSA to reflect the new NIC settings for the PSA-to-MMB communication LAN.
Syntax
/sbin/service
/sbin/service
network restart
y30FJSVpsa stop
y30FJSVpsa start
133 C122-E107-09EN