Configuring Psa (Linux: Red Hat Enterprise Linux); Table 6.2 Confirmation Of The Required Settings For Psa Operation, And Corresponding Features About The Settings - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
6.2

Configuring PSA (Linux: Red Hat Enterprise Linux)

This section describes confirmation of the required settings for PSA operation after operating system installation,
and corresponding features about the settings.
TABLE 6.2 Confirmation of the required settings for PSA operation, and corresponding features about
the settings
Required/
Setting item
As needed
Required Configuring the PSA-
to-MMB
communication LAN
Confirming
management LAN
settings
Confirming SELinux
function settings
Checking the firewall
function (opening
ports)
Setting the management
LAN IP address
As needed Setting the destinations
of traps from a partition
Setting the destinations
of traps and e-mail via
the MMB
Configuring SNMP to
use duplicate disks
Installing a PSA update Not applicable
Uninstalling PSA (*3) Not applicable
*1 Automatic setting: Values are automatically set during PSA installation. You may need to change an
automatically set value. See the section listed in the table.
*2 Manual setting: Values are not automatically set during PSA installation. Make settings as described in the
section referred to in the table.
*3 To operate the PRIMEQUEST 1000 series server, you need to first install PSA. Otherwise, the following
restrictions apply.
- I/O (e.g., PCI Express card, hard disk) failure notification and trap notification to the administrator are
disabled.
- Failure notification using symptom detection and trap notification to the administrator are disabled.
- Threshold exceeded in S.M.A.R.T. monitoring of HDDs
Automatic setting (*1)/
Manual setting (*2)
Automatic setting 6.2.1 Configuring the PSA-to-
MMB communication LAN
Manual setting 6.2.2 Confirming management
LAN settings
Automatic setting 6.2.3 Confirming SELinux function
settings
Automatic setting 6.2.4 Checking the firewall
function (opening ports)
Manual setting 6.2.7 Setting the management LAN
IP address
Manual setting 6.2.5 Setting the destinations of
traps from a partition
Manual setting 6.2.6 Setting the destinations of
traps and e-mail via the MMB
Manual setting 6.2.8 Configuring SNMP to use
duplicate disks
6.2.9 Installing a PSA update
6.2.10 Uninstalling PSA
129
See
C122-E107-09EN