Installing A Psa Update - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
#vi /var/net-snmp/snmpd.conf
oldEngineID 0x19760523
6. Execute the service command to start snmpd.
Syntax
/sbin/service snmpd start
7. Move to the /opt/FJSVpsa/sh/ directory to generate another SNMPv3 password for internal PSA
communication.
Syntax
cd /opt/FJSVpsa/sh/
8. Execute snmpsetup.sh in this directory.
When executed, snmpsetup.sh automatically generates an SNMPv3 password for internal PSA
communication.
Syntax
./snmpsetup.sh install
9. Start PSA.
Syntax
/sbin/service y30FJSVpsa start
6.2.9

Installing a PSA update

This section describes how to install a PSA update in Red Hat Enterprise Linux.
Execute the following commands in the order shown to first stop PSA services and then install the PSA package
to update PSA.
The following description assumes that the work directory (in the example below, $WORK_DIR) has the PSA
package (FJSVpsa-$VER-$REL.tar.gz) already mapped.
Syntax
/sbin/service y30FJSVpsa stop
cd $WORK_DIR/FJSVpsa
./INSTALL.sh
147 C122-E107-09EN