Configuring Snmp To Use Duplicate Disks - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
[NETWORK]
ManagementIP=192.168.0.1
Restart PSA to reflect the new NIC setting for the management LAN.
Syntax
/sbin/service y30FJSVpsa stop
/sbin/service y10FJSVpsa start
/sbin/service y30FJSVpsa start
For details on how to specify any duplication of the management LAN with PRIMECLUSTER GLS, see the
applicable PRIMECLUSTER manuals.
To use PRIMECLUSTER linkage, configure the firewall for the management LAN interfaces. After making those
settings, follow the procedure in 5.2.4 Checking the firewall function (opening ports). Then, configure the
management LAN interfaces.
6.2.8

Configuring SNMP to use duplicate disks

This section describes the required settings for using duplicate disks.
Remarks
Make settings only as needed.
You can use duplicate disks from a partition in a single cabinet to configure a new partition. To do so, you need to
manually change EngineID of SNMPv3 for internal PSA communication.
Change EngineID by using the following procedure. Perform the procedure with root privileges.
Operations
1. Execute the ps command to check whether PSA is active.
Syntax
ps ax | grep psa
Example of output
If the command displays the processes in /opt/FJSVpsa/bin/ as follows, PSA is running.
# ps ax | grep psa
4562 ?
FJSVpsa/
global/pmpsa.conf
4563 ?
4564 ?
4565 ?
S 0:00 /opt/FJSVpsa/bin/pm
S 0:18 /opt/FJSVpsa/bin/loggetd
S 0:06 /opt/FJSVpsa/bin/sisp -p /
S 0:00 /opt/FJSVpsa/bin/mmbm -p /
-o 70 /etc/opt/\
145
-p /
C122-E107-09EN