Fujitsu PRIMEQUEST 1000 Series Installation Manual page 12

PRIMEQUEST 1000 Series Installation Manual
Preface
Work
category
Normal The unit may be damaged or operating abnormally.
operation - Follow the precautions, warnings, and instructions shown on the
main unit.
- Do not block the vent holes.
- Do not install the main unit in a location exposed to direct sunlight
or close to a device that may generate large amounts of heat.
- Do not install the main unit in a location exposed to large amounts
of dust, corrosive gas, or salt spray.
- Do not install the main unit in a location subject to strong vibration.
Install the main unit on a flat surface.
- Use grounded Category 3 wiring or better. Using another type of
grounded wiring may cause abnormal operation.
- Do not route cables under the main unit. Do not allow cables to
become taut.
- Do not disconnect the power cables while the main unit power is on.
- If it is hard to push the connector latch of a LAN cable or other cable
when attempting to disconnect the cable, push it with a flathead
screwdriver. Forcibly inserting a finger may cause personal injury
or damage the unit.
- Do not place anything on top of the main unit. Do not work above
or on top of the main unit.
- Prevent rapid rises in the ambient temperature during winter. Such
an abrupt temperature change may cause condensation to form in the
main unit. Allow sufficient warm-up time before starting operation.
- Do not install the main unit close to a photocopier, air-conditioning
unit, welder, or other device that generates electromagnetic noise.
- Do not install the main unit close to a device that generates large
amounts of electrical noise.
- Do not connect the main unit to the same power supply line as an
elevator in the facility or other equipment that would expose it to
sudden voltage drops.
- Implement antistatic measures at the installation site.
- Confirm that the power supply voltage and frequency are adequate
according to the respective ratings shown on the main unit.
- Do not insert or drop foreign matter into the openings of the main
unit. The main unit contains high-voltage components. If any
metallic matter or other electro-conductive object enters the main
unit through an opening, it may cause a short circuit. This may lead
to fire, electric shock, or damage to the main unit.
- For details on maintenance of the main unit, contact the distributor
where you purchased your product, or your sales representative.
Warning
x
Location
2.1 Safety
Precautions
C122-E107-09EN