Setting The Watchdog Timer For Monitoring After A Stop Error (Fatal System Error); Setting The Management Lan Ip Address - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
6.4.7 Setting the Watchdog Timer for monitoring after a STOP error (fatal
system error)
If a STOP error (fatal system error) occurs in the system, the following situation results.
- After you select [Partition] - [Power Control] from the MMB Web-UI, the window displays "Stop Error"
under [System Progress] for the relevant partition.
- The operating system acquires a memory dump.
You can set monitoring with the Watchdog Timer to perform recovery after the system freezes or otherwise becomes
unresponsive in the above event.
Immediately after the specified time elapses, the MMB performs a Hard Reset to reboot the operating system.
Operations
1. Open the following file:
PSA installation folder\etc\opt\FJSVpsa\usr\pnwatchdog.conf
Example: C:\fujitsu\FJSVpsa\etc\opt\FJSVpsa\usr\pnwatchdog.conf
2. Specify the value of the following key. The default is 0.
Section: [WATCHDOG]
Key: [TIMER]
Setting value (unit: seconds): 0 (Watchdog Timer disabled),
1 to 6000 (Watchdog Timer monitoring time)
Remarks
Determine the setting value by measuring the time taken for a memory dump in the applicable partition. If the
measured time exceeds 6000 seconds (one hour and 40 minutes), specify 0 (Watchdog Timer disabled).
If the specified time is too short for a memory dump, the Watchdog Timer times out and triggers a Hard Reset. In
such cases, a memory dump cannot normally be acquired.
6.4.8

Setting the management LAN IP address

Set the partition management LAN IP address in PSA. For details on the management LAN, see 1.3 Management
LAN in the PRIMEQUEST 1000 Series Administration Manual (C122-E108EN).
Note
Here, set the IP address on the partition instead of the IP address on the MMB.
Edit the PSA installation folder \etc\opt\FJSVpsa\usr\ipsetup.conf file.
Change the following IP address in an editor or similar application.
Syntax
[NETWORK]
ManagementIP=<management LAN IP address>
Example of input
183 C122-E107-09EN