Configuring Psa (Windows Server 2003); Table 6.7 Confirmation Of The Required Settings For Psa Operation, And Corresponding Features About The Settings - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
6.3

Configuring PSA (Windows Server 2003)

This section describes confirmation of the required settings for PSA operation after operating system installation,
and corresponding features about the settings.
TABLE 6.7 Confirmation of the required settings for PSA operation, and corresponding features about
the settings
Required/
As needed
Required Configuring the PSA-to-
MMB communication LAN
Confirming management
LAN settings
Configuring the
Windows Firewall
Setting the management
LAN IP address
As needed Setting the destinations of
traps from a partition
Setting the destinations of
traps and e-mail via the
MMB
Setting Watchdog for
monitoring after a STOP
error (fatal system error)
Installing a PSA update
Uninstalling PSA (*3)
*1 Automatic setting: Values are automatically set during PSA installation. You may need to change an
automatically set value. See the section listed in the table.
*2 Manual setting: Values are not automatically set during PSA installation. Make settings as described in the
section referred to in the table.
*3 To operate the PRIMEQUEST 1800E server, you need to first install PSA. Otherwise, the following restrictions
apply.
- I/O (e.g., PCI Express card, hard disk) failure notification and trap notification to the administrator are
disabled.
- Failure notification using symptom detection and trap notification to the administrator are disabled.
- Threshold exceeded in S.M.A.R.T. monitoring of HDDs
- Operations management software cannot collect information on the partition side.
- Even under an REMCS agreement, no software errors are reported.
Remarks
Automatic setting (*1)/
Setting item
Manual setting (*2)
Manual setting
Manual setting
Manual setting
Manual setting
Manual setting
Manual setting
Manual setting
Not applicable
Not applicable
6.3.1 Configuring the PSA-to-MMB
communication LAN
6.3.2 Confirming management LAN
settings
6.3.5 Configuring the Windows
Firewall
6.3.7 Setting the management LAN
IP address
6.3.3 Setting the destinations of traps
from a partition
6.3.4 Setting the destinations of traps
and e-mail via the MMB
6.3.6 Setting the Watchdog Timer
for monitoring after a STOP error
(fatal system error)
6.3.8 Installing a PSA update
6.3.9 Uninstalling PSA
149
See
C122-E107-09EN