Connecting The Mmb Console Pc; Figure 3.1 Mounting Location And External Interfaces Of The Mmb; Table 3.2 External Interfaces Of The Mmb; Table 3.3 Settings For Terminal Software - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 3 Work before Operating System Installation
All screenshots are display examples, and the actually displayed contents vary depending on the system
configuration and other factors.
3.3.1

Connecting the MMB console PC

This section describes how to connect the MMB console PC.
To reconfigure the system for actual operation, connect the COM port on the MMB console PC to the RS-232C
port (external interface) on the MMB by using an RS-232C crossover cable. For details on the mounting location
and external interfaces of the MMB, see

FIGURE 3.1 Mounting location and external interfaces of the MMB

TABLE 3.2 External interfaces of the MMB

External interface
RS-232C (COM port)
LAN 100Base-TX
LAN 1000Base-T
Make the following settings for the terminal software for the COM port connection.

TABLE 3.3 Settings for terminal software

Setting item
Bits per second
FIGURE 3.1 Mounting location and external interfaces of the
Quantity
1 A field engineer uses this port to set up the device. It is not used in
ordinary operation.
2 Ports used for maintenance
- LOCAL: CE port
- REMOTE: REMCS port
2 USER port
19200
21
Remarks
Value
MMB.
C122-E107-09EN