Installing Psa; Automatic Configuration During Psa Installation; Table B.4 Settings Automatically Added/Changed During Psa Installation - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
APPENDIX B Manual PSA Installation and Uninstallation
- To use a firewall tool other than iptables:
Stop the iptables service.
B.1.3

Installing PSA

Execute the following command to install the PSA package.
The following explanation is based on the assumption that the PSA package (FJSVpsa-$VER-$REL.tar.gz) has
been extracted in the work directory ($WORK_DIR):
Syntax
cd $WORK_DIR/FJSVpsa
./INSTALL.sh
B.1.4

Automatic configuration during PSA installation

The following table lists settings for PSA operation. The installer automatically adds or updates these settings during
PSA installation.

TABLE B.4 Settings automatically added/changed during PSA installation

Target
syslog.conf file
snmpd.conf file
snmptrapd.conf file
services files
snmptrapd start option
snmpd start option
Dedicated PSA-to-MMB
communication LAN interface
iptables setting
SELinux configuration file
(/etc/selinux/config)
Action
Add
setting
Add
setting
Add
setting
Add Added port: The installer does not check for duplicate port
setting numbers when adding a setting to the fj-webgate (24450)
services file. Change the setting as needed.
Change
Change
Set IP Referring to 6.2.1 Configuring the PSA-to-MMB
address communication
Add Only a chain for PSA-MMB communication is created during
setting manual installation of PSA version 2.6 or later.
Referring to Checking the firewall function (opening ports) in
B.1.6 Settings after PSA
chain for PSA-MMB communication to INPUT and OUTPUT
chains manually.
Change SELinux is disabled only for RHEL5. If SELinux is disabled, do
not change the settings.
237
Remarks
LAN, change settings as needed.
installation, add the jump setting for the
C122-E107-09EN