Configuring Psa (Windows Server 2008); Table 6.9 Confirmation Of The Required Settings For Psa Operation, And Corresponding Features About The Settings - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
6.4

Configuring PSA (Windows Server 2008)

This section describes confirmation of the required settings for PSA operation after operating system installation,
and corresponding features about the settings.
TABLE 6.9 Confirmation of the required settings for PSA operation, and corresponding features about
the settings
Required/ Setting item
As needed
Required Configuring the PSA-to-
MMB communication
LAN
Confirming management
LAN settings
Installing the PSHED
Plugin driver
Configuring the
Windows Firewall
Setting the management
LAN IP address
As needed Setting trap destinations
Setting the destinations of
traps and e-mail via the
MMB
Setting Watchdog for
monitoring after a STOP
error (fatal system error)
Installing a PSA update
Uninstalling PSA (*3)
*1 Automatic setting: Values are automatically set during PSA installation. You may need to change an
automatically set value. See the section listed in the table.
*2 Manual setting: Values are not automatically set during PSA installation. Make settings as described in the
section referred to in the table.
*3 To operate the PRIMEQUEST 1800E server, you need to first install PSA. Otherwise, the following restrictions
apply.
- I/O (e.g., PCI Express card, hard disk) failure notification and trap notification to the administrator are
disabled.
- Failure notification using symptom detection and trap notification to the administrator are disabled.
- Threshold exceeded in S.M.A.R.T. monitoring of HDDs
- Operations management software cannot collect information on the partition side.
Automatic setting (*1)/
Manual setting (*2)
Manual setting 6.4.1 Configuring the PSA-to-
MMB communication LAN
Manual setting 6.4.2 Confirming management
LAN settings
Manual setting 6.4.3 Installing the PSHED Plugin
driver
Manual setting 6.4.6 Configuring the Windows
Firewall
Manual setting 6.4.8 Setting the management
LAN IP address
Manual setting 6.4.4 Setting the destinations of
traps from a partition
Manual setting 6.4.5 Setting the destinations of
traps and e-mail via the MMB
Manual setting 6.4.7 Setting the Watchdog Timer
for monitoring after a STOP error
(fatal system error)
Not applicable 6.4.9 Installing a PSA update
Not applicable 6.4.10 Uninstalling PSA
163
See
C122-E107-09EN