Installing The Operating System; Table 4.2 Operating System Installation By Svim - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 4 Installing the Operating System and Bundled Software
2. Mount the disk image of the RHEL distribution DVD on remote storage.
3. Change the boot order to give the highest priority to booting the storage unit where the operating system is
installed.
For details, see 1.3.1 [Power Control] window in the PRIMEQUEST 1000 Series Tool Reference (C122-
E110EN).
4.3.3

Installing the operating system

This section describes the operating system installation with SVIM.
SVIM can perform the following types of operating system installation. For the procedure for each mode, see the
ServerView Suite ServerView Installation Manager.

TABLE 4.2 Operating system installation by SVIM

Mode
Quick mode You can simply use the minimum settings
necessary for operating system installation.
This mode uses Fujitsu's recommended
settings.
Guide mode You can specify setup information by
following the instructions of the wizard.
You can save the specified information in a
configuration file for use during
reinstallation.
All screenshots are display examples, and the actually displayed contents vary depending on the system
configuration and other factors.
Operations
1. Make the setting for booting the partition from remote storage.
For details on the setting, see 1.6.3 Remote operation (BMC) in the PRIMEQUEST 1000 Series
Administration Manual (C122-E108EN).
2. Insert ServerView Suite DVD1 into the DVD drive. Then, power on the partition.
Remarks
You can boot from the DVD drive either by selecting [Force boot from DVD] from [Boot Selector], or by
specifying the DVD drive as the highest-priority device to boot from, in UEFI mode.
If the operating system supports UEFI mode, you can install it in UEFI mode by using the following procedure
to change the boot order.
1. After powering on the partition, press and hold down any key ([Space] key, for example) other than
the [Enter] key while the FUJITSU logo is displayed, to display the Boot Manager Front Page.
2. Select the following items from the menu in the order given in the Boot Manager Front Page:
[Boot Maintenance Manager] - [Boot Options] - [Change Boot Order] - [Change the order]
Functional outline
68
Remarks
Use this mode to readily install the OS.
This mode enables detailed settings.
Use the mode if you want to configure
installation with detailed RAID and
OS settings.
C122-E107-09EN