Fujitsu PRIMEQUEST 1000 Series Installation Manual page 4

PRIMEQUEST 1000 Series Installation Manual
Preface
Organization of this manual
This manual is organized as follows.
CHAPTER 1 Installation Overview
Chapter 1 describes the workflow up to actual operation of the PRIMEQUEST 1000 series server.
CHAPTER 2 Preparing for Main Unit Installation
Chapter 2 describes the preparation before main unit installation. This preparation includes work up to power
cable connection.
CHAPTER 3 Work before Operating System Installation
Chapter 3 describes the work that must be done before you install an operating system on the PRIMEQUEST
1000 series server. The chapter also describes settings for actual operation and various setup work.
CHAPTER 4 Installing the Operating System and Bundled Software
Chapter 4 describes how to install the operating system and bundled software.
CHAPTER 5 Work after Operating System Installation (PRIMEQUEST 1800E2)
Chapter 5 describes how to make various necessary settings after operating system installation on the
PRIMEQUEST 1800E2.
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
Chapter 6 describes how to make PSA and various other necessary settings after operating system installation
on the PRIMEQUEST 1800E.
CHAPTER 7 Work after Installation
Chapter 6 describes the work performed after PRIMEQUEST 1000 series installation. This work includes
configuring NTP and security.
CHAPTER 8 Powering On and Off a Partition
Chapter 7 describes partition power control.
APPENDIX A Lists of Settings (Links)
Appendix A provides links to Appendix A List of Settings in the PRIMEQUEST 1000 Series Tool
Reference (C122-E110EN).
APPENDIX B Manual PSA Installation and Uninstallation
Appendix B describes how to manually install and uninstall PSA for a specific operating system.
APPENDIX C Software (Links)
Appendix C provides a link to 3.3 Bundled Software in the PRIMEQUEST 1000 Series General
Description (C122-B022EN).
APPENDIX D Configuring the SAN Boot Environment
Appendix D is a link to the PRIMEQUEST 1000 Series SAN Boot Environment Configuration Manual (C122-
E155EN).
APPENDIX E Notes on VMware Installation
Appendix E describes the procedure for installing a built-in hard disk in a RAID environment in VMware
vSphere and provides notes on installation.
APPENDIX F Setting up the NTP Server (Windows)
Appendix G describes how to specify and set of an NTP server for a specific Windows operating system.
ii C122-E107-09EN