Figure E.5 Network Configuration Immediately After Installation Of Os - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
APPENDIX E Notes on VMware Installation

FIGURE E.5 Network configuration immediately after installation of OS

Remark
For details on each command used in the settings below, use man for confirmation.
Note
Do not set the host name before setting the IP address of vswif0, which exists by default immediately after the
installation of the operating system. If you do so, VMware 4.x may change the value of /etc/hosts to an unintended
value.
The description here is based on the assumption that vswif0 is used as the management LAN.
Confirming the PSA-to-MMB communication LAN and management LAN
1. The PSA-MMB communication LAN uses the physical adapter assigned BUS number 0000:00:19.0.
The management LAN uses an arbitrary physical adapter.
Execute the esxcfg-nics command to confirm the physical adapters used for the PSA-to-MMB
communication LAN and management LAN.
# esxcfg-nics -l
Name PCI
MAC Address
vmnic0 00:19.00
00:17:42:de:7c:4b
Intel Corporation 82567LF-2 Gigabit Network Connection
vmnic1 0d:00.00
00:17:42:9b:dc:b4
Intel Corporation 82576 Gigabit Network Connection
vmnic2 0d:00.01
00:17:42:9b:dc:b5
Intel Corporation 82576 Gigabit Network Connection
Driver Link
MTU
e1000e Up
1500 \
igb Up
1500 \
igb Down
1500 \
271
Speed Duplex\
Description
100Mbps Half \
100Mbps Full \
0Mbps Half \
C122-E107-09EN