Manually Installing Psa (Linux: Red Hat Enterprise Linux); Installation Flow; Checks Before Psa Installation - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
APPENDIX B Manual PSA Installation and Uninstallation
B.1

Manually Installing PSA (Linux: Red Hat Enterprise Linux)

This section describes how to manually install PSA in Linux (Red Hat Enterprise Linux).
Remarks
Be sure to install PSA for PRIMEQUEST 1800E. Otherwise, the following restrictions apply.
- I/O (e.g., PCI Express card, hard disk) failure notification and trap notification to the administrator are
disabled.
- Failure notification using symptom detection and trap notification to the administrator are disabled.
- Threshold exceeded in S.M.A.R.T. monitoring of HDDs
- Operations management software cannot collect information on the partition side.
- Even under an REMCS agreement, no software errors are reported.
- Hot maintenance of hard disks is disabled. The partition must be stopped for maintenance.
- PRIMECLUSTER linkage is disabled.
B.1.1

Installation flow

For details on how to install PSA, see
details on how to configure PSA, see
Remarks
- After changing the MMB IP address on a partition or the management LAN IP address,
restart PSA. Otherwise, a display error may occur in the [PSA] window of the Web-UI. Moreover, PSA
would not be able to report any detected errors.
- If you use SVIM to install the operating system, you need not manually install PSA. However, after
installation with SVIM, you will need to check and make settings according to
installation and B.1.6 Settings after PSA
B.1.2

Checks before PSA installation

This section describes the checks to make before PSA installation.
Confirming PSA-to-MMB communication LAN settings
Confirming management LAN settings
Confirming the functions required for PSA operation
Confirming the status of the iptables service
Confirming PSA-to-MMB communication LAN settings
For details on how to confirm PSA-to-MMB communication LAN settings, see
MMB communication LAN
Confirming management LAN settings
For details on how to confirm management LAN settings, see
Confirming the functions required for PSA operation
The following table lists the packages required for PSA operation. Execute the rpm command to confirm the
installation of each package.
The packages that must be installed depend on the CPU architecture (x86/x64).
CHAPTER 4 Installing the Operating System and Bundled
B.1 Manually Installing PSA (Linux: Red Hat Enterprise
installation.
and 6.2.7 Setting the management LAN IP
234
B.1.2 Checks before PSA
6.2.1 Configuring the PSA-to-
address.
6.2.2 Confirming management LAN
Software. For
Linux).
settings.
C122-E107-09EN