Confirming Management Lan Settings; Confirming Selinux Function Settings - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
6.2.2

Confirming management LAN settings

Make network settings for the management LAN. If necessary, also configure any duplication with bonding or
PRIMECLUSTER GLS, for example.
After completing the above network settings for the management LAN, perform the operations described in
Checking the firewall function (opening ports)
Note
In the PRIMEQUEST environment, it is necessary to specify OFF for the STP function of the switch that connects
to the management LAN used for communication with the MMB.
6.2.3

Confirming SELinux function settings

This section describes the SELinux settings and how to confirm them.
Other OS settings
- For RHEL5
If the partition OS with PSA installed is running RHEL5, disable the SELinux functions. When installing
PSA, the SELinux functions are automatically disabled. Confirm that the SELinux functions are disabled. If
the SELinux functions are enabled, disable them.
- For RHEL6.0/RHEL6.1
If the partition OS with PSA installed is running RHEL6.0/RHEL6.1, disable the SELinux functions. When
installing PSA, the SELinux functions are not automatically disabled. Check the SELinux function setting.
If the SELinux functions are enabled, disable them.
- For RHEL6.2 or later
If the partition OS with PSA installed is running RHEL6.2 or later, it operates irrespective of whether the
SELinux functions are enabled or disabled.
The procedure for confirming the SELinux function setting and disabling the SELinux functions is as follows.
Confirm that the following command displays "disabled" when operating the system with the SELinux functions
disabled. If the command displays anything other than "disabled," disable the functions by editing the config file
(/etc/selinux/config).
Confirming settings
#cd /etc/selinux/
#more config
.....
.....
SELinux=disabled
Changing settings
# vi /etc/selinux/config
.....
.....
SELinux=disabled
and 6.2.7 Setting the management LAN IP
← Confirm this.
← Edit this.
134
6.2.4
address.
C122-E107-09EN