Specifying The Ip Address For The Pc To Be Used As The Mmb Console; Connecting The Mmb Console Pc To The Mmb User Port; Figure 2.1 Location Of The Mmb User Port - Fujitsu PRIMEQUEST 500A Series Installation Manual

CHAPTER 2 Setup
2.2.1.1 Specifying the IP address for the PC to be used as the MMB
console
On the user's PC to be used as the MMB console, specify the IP address of that PC.
For information on the procedure, see the manuals for the PC.
2.2.1.2

Connecting the MMB console PC to the MMB user port

Connect the user's MMB console PC to the MMB user port by using a LAN cable.
After connection is complete, the MMB console PC becomes able to communicate
with the MMB LAN.
The PRIMEQUEST 580A/540A/580/540/480/440 uses a redundant MMB
configuration in which one MMB is active and the other is a standby. When
connecting the cable to an MMB LAN port during the setup, select the port of the
active MMB (ACT LED: normally MMB#0 is on) indicated by the LED.
Remarks: BMM#1 is supported only in the PRIMEQUEST 500A/500 series.
2-4

Figure 2.1 Location of the MMB user port

C122-E001-10EN