Chapter 6 Installing Suse Linux Enterprise Server 11 Service Pack 2; Installing Sles11 Sp2; Preparing For Sles11 Sp2 Installation; Installing The Os And Bundled Software - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual

CHAPTER 6
This chapter describes how to install SUSE Linux Enterprise Server 11 Service Pack 2 (referred to below as
SLES11 SP2) on the PRIMEQUEST 1000 series server.
6.1

Installing SLES11 SP2

This section describes how to install SLES11 SP2.
All screenshots appearing below are display examples whose contents vary depending on the system
configuration, etc.

6.1.1 Preparing for SLES11 SP2 installation

Make settings for installation in advance.
For details on this advance setup, see 4.4.1 Advance setup in the PRIMEQUEST 1000 Series Installation
Manual (C122-E107EN).
For a multipath configuration, disconnect the secondary cable connected to the server.
Specifically, use a single path configuration (connection with only one FC cable) until you complete the
installation of the operating system and multipath driver.
If the server is in a multipath connection state, the operating system cannot be installed correctly. Manually
disconnect the secondary FC path beforehand.
Remarks
Disconnect all HDDs, including the built-in HDD, other than the HDD with the installation destination LUN.
You can confirm that all of them are disconnected, by starting the Boot Manager Front Page and selecting [Boot
Maintenance Manager] - [Boot Options] - [Change Legacy HDD Boot Priority].
For details on how to check the connected HDDs, see "How to check the connected HDDs" in 4.1.1 Preparing
for Windows Server 2008/2012 installation.

6.1.2 Installing the OS and bundled software

Use SVIM to install the OS and bundled software.
1. Make the setting for booting the partition from a remote storage device.
Installing SUSE Linux Enterprise
Server 11 Service Pack 2
143