Concluding Steps; Using The Front Management Lan Connector - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

Ê Connect the front panel cables to the system board as described in section
"Connecting front panel cables to the system board" on page

13.2.1.3 Concluding steps

"Installing the system fan holder" on page 77
Ê
"Reassembling" on page 64
Ê
"Connecting the server to the mains" on page 74
Ê
"Switching on the server" on page 75
Ê
"Enabling BitLocker functionality" on page 100
Ê

13.2.1.4 Using the front management LAN connector

In order to use the front management LAN connector to access the iRMC S3
management controller, please proceed as follows:
Ê Ensure that Management LAN has been enabled in the BIOS:
Ê Enter the BIOS.
Ê Select the Server Mgmt menu.
Ê Under iRMC LAN Parameters Configuration, make sure that the
Management LAN setting is set to Enabled.
Ê Save your changes and exit the BIOS.
I
The front management LAN connector can be used to access the
iRMC S3 with either of the Management LAN Port settings enabled,
Management or Shared.
For detailed information on how to access the BIOS and modify
settings, refer to the corresponding BIOS Setup Utility reference
manual.
Ê Connect a client computer (e.g. notebook) to the front management LAN
connector.
I
It is not possible to simultaneously access the iRMC S3 from the front
and rear management LAN connectors. As soon as a LAN cable is
connected to the front management LAN connector, the iRMC S3
cannot be accessed via the rear management LAN connector.
TX150 S8 / TX200 S7
Upgrade and Maintenance Manual
Front panel and external connectors
338.
343