Show L2Protocol-Tunnel - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

show l2protocol-tunnel

To display the protocols that are tunneled on an interface or on all interfaces, use the show
l2protocol-tunnel command.
Syntax Description interface
interface
mod/port
summary
Command Default This command has no default settings.
Command Modes EXEC (>)
Privileged EXEC (#)
Command History Release
12.2(14)SX
12.2(17a)SX
12.2(17d)SXB
12.2(33)SRA
12.2(33)SXI
15.0(1)MR
Usage Guidelines
The show l2protocol-tunnel command displays only the ports that have protocol tunneling enabled.
The show l2protocol-tunnel summary command displays the ports that have protocol tunneling
enabled, regardless of whether the port is down or currently configured as a trunk.
Examples This example shows how to display the protocols that are tunneled on all interfaces:
Router# show l2protocol-tunnel
COS for Encapsulated Packets: 5
OL-23890-01
show l2protocol-tunnel [{interface interface mod/port} | summary}]
(Optional) Specifies the interface type; only gigabitethernet is supported
Module and port number.
(Optional) Displays a summary of a tunneled port.
Modification
Support for this command was introduced on the Supervisor Engine 720.
The show l2protocol-tunnel summary command output was changed to
display the following information:
Global drop-threshold setting
•
• Up status of a Layer 2-protocol interface tunnel
Support for this command on the Supervisor Engine 2 was extended to the
12.2 SX release.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was changed to add the optional vlan vlan keyword and
argument.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release only supports the gigabitethernet value with the interface
keyword. This release does not support the vlan vlan keyword and
argument.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show l2protocol-tunnel
547