Ethernet Cfm Traceroute Cache - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ethernet cfm traceroute cache

To enable caching of Ethernet connectivity fault management (CFM) data learned through traceroute
messages, use the ethernet cfm traceroute cache command in global configuration mode. To disable
caching, use the no form of this command.
Syntax Description This command has no arguments or keywords.
Command Default
Caching is disabled.
Command Modes
Global configuration (config)
Command History Release
12.2(33)SRA
12.4(11)T
12.2(33)SXH
12.2(33)SXI2
12.2(33)MRA
15.0(1)MR
Usage Guidelines
Setting a traceroute cache allows you to store the results of traceroute operations initiated on the device.
Examples
The following example shows how to enable Ethernet CFM traceroute cache:
Router(config)# ethernet cfm traceroute cache
Related Commands
ethernet cfm traceroute
cache hold-time
ethernet cfm traceroute
cache size
OL-23890-01
ethernet cfm traceroute cache
no ethernet cfm traceroute cache
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(11)T.
This command was integrated into Cisco IOS Release 12.2(33)SXH.
This command was integrated into Cisco IOS Release 12.2(33)SXI2.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Sets a maximum time that Ethernet CFM traceroute cache entries will
be retained.
Sets a maximum number for entries in an Ethernet CFM traceroute
cache table.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm traceroute cache
133