Table of Contents
Advertisement
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show link-protection
To display the status of configured link protection groups, use the show link-protection command in
user EXEC or privileged EXEC mode.
Syntax Description
detail
group-number
Command Modes
User EXEC (>)
Privileged EXEC (#)
Command History
Release
15.0(1)MR
Usage Guidelines
Use this command to configure Microwave 1+1 Hot Standby Protocol (HSBY). For more information
about HSBY, see the
Release
Examples
The following examples provide sample output from the show link-protection command:
Router# show link-protection
CFM Status: Enabled
------------------------------
Group:
------------------------------
1
1
Router# show link-protection detail
Management VLAN: 100
CFM Status: Enabled
Group: 1
----------------
Port: Gi0/1
Domain: ODU1
ECCM vlan: 1
PCCM vlan: 16
ODU Status: Active
ODU Radio: On
Data vlans: Forwarding
Port: Gi0/2
Domain: ODU2
ECCM vlan: 2
OL-23890-01
show link-protection [detail [group group-number]]
Displays the details of the link protection status of each port.
Specifies a single link protection group to display.
Modification
This command was introduced.
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide,
15.0(1)MR.
Port:
ODU Status:
Gi0/1
Active
Gi0/2
Standby
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show link-protection
549
Advertisement
Table of Contents
