Cisco MWR 2941 Command Reference Manual page 448

set ip precedence tunnel
This is the designed behavior. We recommend that you configure only L2TPv3 (or GRE) tunnel marking
and reconfigure any peers configured with the ip tos command to use L2TPv3 (or GRE) tunnel marking.
For Cisco IOS Release 12.4(15)T2, marking GRE-tunneled packets is supported only on platforms
Note
equipped with a Cisco RPM-XF.
Examples The following example shows the set ip precedence tunnel command used in a tunnel marking
configuration. In this example, a class map called "MATCH_FRDE" has been configured to match
traffic on the basis of the Frame Relay discard eligible (DE) bit setting. Also, a policy map called
"policy1" has been created within which the set ip precedence tunnel command has been configured.
Router> enable
Router# configure terminal
Router(config)# class-map MATCH_FRDE
Router(config-cmap)# match fr-de
Router(config-cmap)# exit
Router(config)# policy-map policy1
Router(config-pmap)# class tunnel
Router(config-pmap-c)# set ip precedence tunnel 7
Router(config-pmap-c)# end
You must still attach a policy map to an interface or ATM PVC using the service-policy command.
Note
Policy maps with this tunnel marking are not accepted in the output direction. For more information
about attaching a policy map to an interface or ATM PVC, see the "Applying QoS Features Using the
MQC" module of the Cisco IOS Quality of Service Solutions Configuration Guide.
Related Commands Command
ip tos
set ip dscp tunnel
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
430
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Specifies the ToS level for IP traffic in the TN3270 server.
Sets the DSCP value in the header of an L2TPv3 tunneled packet.
OL-23890-01