Cisco MWR 2941 Command Reference Manual page 129

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Usage Guidelines
If a higher priority defect occurs after a lower priority defect has triggered an alarm but before the alarm
has reset, immediately issue another fault alarm for the higher priority defect.
Output of the show running all command displays "ethernet cfm alarm delay 2500" when the default
value for the delay option is configured and "ethernet cfm alarm reset 10000" when the default value for
the reset option is configured.
Examples
The following example shows how to set up notification for all defects:
Router(config)# ethernet cfm alarm notification all
The following example shows how to set the time during which one or more defects must be
present before a fault alarm is issued to 5000 milliseconds:
Router(config)# ethernet cfm alarm delay 5000
Related Commands Command
show running all
OL-23890-01
Description
Shows the running configuration with default values.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm alarm
111