Cisco MWR 2941 Command Reference Manual page 98

cns id
Command History Release
12.2(2)XB
12.2(8)T
12.3(1)
12.3(14)T
12.2(25)S
12.2(33)SRA
12.2(33)SB
12.2(33)SXI
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines Use this command to set the unique ID to the CNS configuration agent, which then pulls the initial
configuration template to the Cisco IOS device during bootup.
You can set one or all three IDs: the config ID value for CNS configuration services, the event ID value
for CNS event services, and the image ID value for CNS image agent services. To set all values, use the
command three times.
To set the CNS event ID to the host name of the Cisco IOS device, use the no form of this command
with the event keyword. To set the CNS config ID to the host name of the Cisco IOS device, use the no
form of this command without the event keyword. To set the CNS image ID to the host name of the
Cisco IOS device, use the no form of this command with the image keyword.
Unique Device Identifier
Each identifiable Cisco product is an entity, as defined by the Entity MIB (RFC-2737) and its supporting
documents. Some entities, such as a chassis, will have subentities like slots. An Ethernet switch might
be a member of a superentity, such as a stack. Most Cisco entities that are orderable products will leave
the factory with an assigned UDI. The UDI information is printed on a label that is affixed to the physical
hardware device, and it is also stored electronically on the device in order to facilitate remote retrieval.
To use UDI retrieval, the Cisco product in use must be UDI-enabled.
A UDI consists of the following elements:
•
•
•
The PID is the name by which a product can be ordered; historically, it has been called the "Product
Name" or "Part Number." This identifier is the one to use to order an exact replacement part.
The VID is the version of the product. When a product is revised, the VID is incremented according to
a rigorous process derived from Telcordia GR-209-CORE, an industry guideline that governs product
change notices.
The SN is the vendor-unique serialization of the product. Each manufactured product carries a unique
serial number assigned at the factory, which cannot be changed in the field. The serial number is used
to identify an individual, specific instance of a product.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
80
Modification
This command was introduced on Cisco IAD2420 series IADs.
This command was integrated into Cisco IOS Release 12.2(8)T. The
dns-reverse keyword was removed.
The optional image keyword was added to set an image ID.
The udi keyword was added to use the product UDI as the unique ID.
This command was integrated into Cisco IOS Release 12.2(25)S.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was integrated into Cisco IOS Release 12.2(33)SB.
This command was integrated into Cisco IOS Release 12.2(33)SXI.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Product identifier (PID)
Version identifier (VID)
Serial number (SN)
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01