Switchport Mode - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

switchport mode

To set the interface type, use the switchport mode command in interface configuration mode. Use the
appropriate no form of this command to reset the mode to the appropriate default mode for the device.
Syntax Description
access
dot1q-tunnel
dynamic auto
dynamic desirable
trunk
Command Default
The default setting is dynamic auto.
Command Modes Interface configuration
Command History Release
12.0(7)XE
12.1(1)E
12.1(8a)EX
12.2(2)XT
12.2(8)T
12.2(14)SX
12.2(17d)SXB
15.0(1)MR
Usage Guidelines Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
If you enter a forced mode, the interface does not negotiate the link to the neighboring interface. Ensure
that the interface ends match each other.
The no form of the command is not supported on the Cisco 2600 series, Cisco 3600 series, and
Cisco 3700 series routers.
Cisco Catalyst 6500/6000 Switches and Cisco 7600 Series Routers
If you enter access mode, the interface goes into permanent nontrunking mode and negotiates to convert
the link into a nontrunk link even if the neighboring interface does not agree to the change.
OL-23890-01
switchport mode {access | dot1q-tunnel | dynamic {auto | desirable} | trunk}
no switchport mode
Modification
This command was introduced on the Cisco Catalyst 6000 family switches.
This command was integrated on the Cisco Catalyst 6000 family switches.
The switchport mode private-vlan {host | promiscuous} syntax was added.
Creation of switchports became available on Cisco 2600 series, Cisco 3600 series,
and Cisco 3700 series routers.
This command was integrated into Cisco IOS Release 12.2(8)T for creation of
switchports on Cisco 2600 series, Cisco 3600 series, and Cisco 3700 series routers.
Support for this command was introduced on the Supervisor Engine 720.
Support for this command on the Supervisor Engine 2 was extended to Cisco IOS
Release 12.2(17d)SXB.
This command was integrated into 15.0(1)MR.
Sets a nontrunking, nontagged single VLAN Layer 2 interface.
Sets the trunking mode to TUNNEL unconditionally.
Sets the interface to convert the link to a trunk link.
Sets the interface to actively attempt to convert the link to a trunk link.
Specifies a trunking VLAN Layer 2 interface.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
switchport mode
657