Cisco MWR 2941 Command Reference Manual page 622

show rep topology
This example shows output from the show rep topology segment archive command:
Router# show rep topology segment 1 archive
REP Segment 1
BridgeName
---------------- ---------- ---- ----
sw1_multseg_3750 Gi1/1/1
sw3_multseg_3400 Gi0/13
sw3_multseg_3400 Gi0/14
sw4_multseg_3400 Gi0/13
sw4_multseg_3400 Gi0/14
sw5_multseg_3400 Gi0/13
sw5_multseg_3400 Gi0/14
sw2_multseg_3750 Gi1/1/2
sw2_multseg_3750 Gi1/1/1
sw1_multseg_3750 Gi1/1/2
Related Commands Command
rep segment
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
604
PortName Edge Role
Pri Open
Open
Open
Open
Open
Open
Open
Alt
Open
Sec Open
Description
Enables REP on an interface and assigns a segment ID. This command is also
used to configure a port as an edge port, a primary edge port, or a preferred
port.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01