Network-Clock Synchronization Automatic - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

network-clock synchronization automatic

To enable automatic selection of a clock synchronization source, use the network-clock
synchronization automatic command in global configuration mode. To disable automatic clock
selection, use the no form of this command.
Syntax Description This command has no arguments or keywords.
Command Default
This command is disabled by default.
Command Modes
Global configuration (config)
Command History Release
15.0(1)MR
Usage Guidelines This command enables automatic clock selection based on the G.781 standard.
To use this command, you must remove any network-clock select statements from the router
configuration.
Examples
This example shows how to enable automatic clock synchronization:
Router(config)# network-clock synchronization automatic
Router(config)#
Related Commands Command
network-clock select
OL-23890-01
network-clock synchronization automatic
no network-clock synchronization automatic
Modification
This command was introduced.
Description
Names a source to provide timing for the network clock and to specifies
the selection priority for the clock source.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock synchronization automatic
275