Table of Contents
Advertisement
link-protection group pccm vlan
link-protection group pccm vlan
To specify the VLAN used for ODU-to-ODU Continuity Check Messages (P-CCMs) for Microwave 1+1
Hot Standby Protocol (HSBY), use the link-protection group pccm vlan command in global
configuration mode. To remove a P-CCM configuration, use the no form of this command.
Syntax Description
group-number
vlan-id
Defaults
The default PCCM VLAN is 16.
Command Modes
Global configuration
Command History
Release
15.0(1)MR
Usage Guidelines
VLANs 1-50 are reserved for IDU-to-ODU Continuity Check Message (E-CCM) and ODU-to-ODU
Continuity Check Message (P-CCM) VLANs.
Use this command to configure Microwave 1+1 Hot Standby Protocol (HSBY). For more information
about HSBY, see the
Release
Examples
In the following example, VLAN 30 is configured for PCCM traffic.
Router# configure terminal
Router(config)# link-protection group 100 pccm vlan 30
Related Commands
Command
link-protection group
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
210
link-protection group group-number pccm vlan vlan-id
no link-protection group group-number pccm vlan vlan-id
The link-protection group number. Valid values are 1–65535.
Specifies the management VLAN number. Valid values are 16–50.
Modification
This command was introduced.
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide,
15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Specifies the link-protection group of which the MEP interface is a
member.
OL-23890-01
Advertisement
Table of Contents
