Switchport Stacking-Partner - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

switchport stacking-partner

Stacking allows you to configure two switch modules in a single chassis to behave as a single switch.
This is done by selecting one port from each switch module and configuring it to be a stacking partner.
You must then use a cable to connect the stacking partners from each switch module to physically stack
the switch modules. Any one port in a switch module can be designated as the stacking partner for that
switch module.
Use the switchport stacking-partner command to configure a stacking partner port. You can use this
command on the onboard gigabitEthernet ports or on fastEthernet ports on the HWIC-D-9ESW card. Use
the no form of this command to remove the configuration.
Syntax Description
interface
partner-interface-id
Defaults
There is no default setting.
Command Modes Interface configuration
Command History Release
12.3(8)T4
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Examples
The following example shows the output generated by this command:
Router(config)# interface gigabitethernet0/3
Router(config-if)# switchport stacking-partner interface gigabitethernet0/4
Related Commands Command
show interface switchport
OL-23890-01
switchport stacking-partner interface gigabitethernet partner-interface-id
no switchport stacking-partner interface gigabitethernet partner-interface-id
Specifies the stacking partner interface.
The slot and port number of the stacking partner interface, such as 0/1.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into 15.0(1)MR.
Description
Displays status information about the switchport.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
switchport stacking-partner
661