Using Show Commands To Verify Modular Line Card And Modular Port Adapter Status; Using Show Commands To Display Modular Port Adapter Information - Cisco ASR 9000 Series Installation Manual

Using show Commands to Verify Modular Line Card and Modular Port Adapter Status

Note New interfaces are not available until you configure them.
Using show Commands to Verify Modular Line Card and Modular Port Adapter Status
The following procedure uses show commands to verify that the new modular port adapters (MPAs) are
configured and operating correctly.
1. Use the show running-config command to display the system configuration. Verify that the configuration
includes the new MPA interfaces.
2. Display information about the installed modular line cards (MLCs) using the show diag command.
3. Use the show hw-module fpd location rack/slot/subslot command to verify the FPD version information
of the modular port adapters (MPAs) installed in the system.
Note
If a MPA does not meet the minimum version required, the FPD may need to be updated. See the Cisco ASR
9000 Series Aggregation Services Router System Management Configuration Guide for instructions. If the
update fails, the failing module is powered down and an error message displays on the system console.
4. Use the show platform command to check the state of all the boards in the chassis, including the MLC
and the modular port adapters (MPAs).
The MPA state should be "OK" and the MLC card state should be "IOS XR RUN" in the show platform
command output
5. Finally, you can use the show version command to obtain software version information for the installed
modular line cards (MLCs) as well as interfaces available.

Using show Commands to Display Modular Port Adapter Information

The following tables describe the show commands you can use to display modular port adapter (MPA)
information.
Table 26: show Commands to Display Modular Port Adapter Information
Command
show running-config
show platform
show diag
show hw-module fpd location
rack/slot/subslot
show version
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
92
Type of Information Provided
Router's running configuration and interfaces available in the system.
Router's installed line card and MPA type, slot, and state information.
MPA type in that slot, number of ports, hardware revision, part number, and EEPROM
contents.
FPD version information of modular port adapters (MPAs) in the system.
Cisco IOS XR software version, names and sources of configuration files, and boot
images.
Installing and Removing Line Cards and Transceiver Modules