Ptp Clock-Destination - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ptp clock-destination

Specifies the IP address of a clock destination. This command applies only when the router is in PTP
master unicast mode.
Syntax Description
clock-ip-address
Defaults There is no default setting.
Command Modes
Interface configuration
Command History Release
12.4(19)MR2
12.2(33)MRA
15.0(1)MR
Usage Guidelines
If the router is set to ptp master unicast, you can only configure a single destination. If the router is set
to ptp master unicast negotiation, you do not need to use this command as the router uses negotiation to
determine the IP address of PTP slave devices.
Examples
The following example shows how to configure a PTP announcement:
Router# config t
Router(config)# interface vlan 10
Router(config-if)# ptp clock-destination 192.168.1.2
Router(config-if)# exit
Router(config)# exit
Related Commands Command
ptp enable
ptp master
ptp mode
ptp clock-source
OL-23890-01
ptp clock-destination clock-ip-address
no ptp clock-destination clock-ip-address
The IP address of the clock destination.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Description
Enables PTP mode on an interface.
Sets an interface in master clock mode for PTP clocking
Specifies the PTP mode.
Specifies a PTP clock source.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ptp clock-destination
333